Onga Pump Pantera PPP 750 1.0HP

In need of an Onga Pantera Pool Pump? Mr Pool Man stocks the largest range of 1.0HP pool pumps online from Onga at great prices.

Mr Pool Man is a certified and reputable Onga dealer, all products are backed by standard factory warranty and we provide extensive pre purchase troubleshooting to assist in ensuring the first purchase is the correct one backed with after sales support on all Onga equipment for lasting performance for years to come.

Features:

• Stainless steel motor shaft – A 5/8″ 316 Stainless Steel shaft extends the life of the pump.
• Shaft Sleeve – A nylon shaft sleeve adds additional water ingress protection.
• Mechanical Seal – A heavy-duty 3/4″ 316 Stainless Steel mechanical seal (on all models) provides extended life and longer intervals between servicing.
• Plastic Yoke and Lip-Seal – The wet end design integrates a moulded end-shield cover and lip seal,protecting the motor from water damage.
• Self aligning barrel unions (40mm/50mm) included.
• 2 years limited warranty.

• *Note – Mechanical seal and bearings only covered by 12 month manufacturers warranty

Benefits:

• 5 levels of corrosion resistance
• Elevated mount keeps moisture away from the motor
• Extended life of the pump shaft because of corrosion resistant stainless steel
• Additional water ingress protection 
• Stainless steel mechanical seal provides longer life and longer intervals between servicing
• Plastic Yoke and Lip-Seal protects from water damage 
• Larger lint pot with clear lid makes cleaning faster and easier
• Easy pipe work connection with self aligning barrel unions

Quick Pool Pump Installation Guide:

Installing a pool pump is as simple as swapping out your old pump to a new one. But if the new one isn’t designed to retrofit with your current pump, then don’t worry too much, with some basic tools and some elbow grease, you’ll have your new pump installed in no time. 

• Turn off the power to your pool equipment at the mains and switch off any valves leading to and from the pump to give you a splash free-environment while you work. 
• Detach the pump from the power supply and unscrew the unions. 
• Note: If you have an older pump that’s hard plumbed into your system then you may have to saw off the current pipes. Cut as close to the pump as possible. If this is the case then now might be a good time to install unions. 
• Remove the pump and set aside. Position new pump on where the old pump previously was and assess what kind of plumbing needs to be done. It should be as simple as mounting the pump properly and screwing in unions. But if not, do the necessary plumbing work and connect your pump. 
• Once the pump is plumbed in, open up all the valves and connect the power. 
• Turn on the pump to see if the pump is working. Check for any leaks and that’s it!